Electric Installation – operating the Electric to the Cabinet Print
This instructional guide will help with visit tids site here the planning/installation of this Electrical Power provide for the Acrylic Spas.
Most of our acrylic tubs have actually detachable case panels which cover the whole border associated with bath tub.
When operating the electric through the spa, the access point to the case doesn’t need become put right at the Control Pack location. Our spas try not to come designed with a pre-drilled gap for electric so access could be through some of the cabinet panels.*
*NOTE: We don’t advise setting up the electric by way of a case panel that is situated in front side a Pump, Control Pack, Blower, or Gate Valve. These panels will need to be likely eliminated at some point for upkeep or servicing.
Choosing a spot
Whenever choosing where you can go into the cabinet, do this on the basis of the after:
- safety (do not create hazards that are tripping
- aesthetics
- access points for users to enter the bath tub
- step positioning
- cover opening position (bottom mount lifters could have the address sleep low next to the case)
- address lifter mounts
Producing an Access Aim
A Spade Bit is not recommended since there are no pre-drilled holes, access through the panel is done using a Hole Saw for a clean cut. The best location to put an opening when it comes to cord, is three to five ins up through the base associated with the cabinet panel, and 3 to 4 ins in through the edge that is outside of case panel. Please note that the cabinet panels have timber insulating and framework foam inserts. Make an effort to avoid drilling through the lumber framework since this may damage the support that is structural timber provides.
We don’t suggest coming through the beds base regarding the spa. Then we suggest you take into consideration that you will not be able to slide the tub in any way if this is the most ideal route.
This could pose problem if a site professional is needed to access a region of the bath tub this is certainly against an obstruction such as for instance a wall or deck.
The Control Pack (in which the electric is likely to be connected) will likely be positioned behind among the case panels straight below your Topside Control Panel (precise location will differ according to spa model).
There is certainly space that is enough the cabinet to operate the energy cord through the access point out the Control Pack even as we don’t totally fill the cavity with spray foam. The ability cable will have to go into the Control Pack through the hand side that is left.
To find out more about connecting the electric to your circuit breaker, please click on our solution “Electrical Installation – Correct Wiring for a 240V Supply“.
In the event that you need any further support, please contact Consumer Service.